Hydraulic Separators Details
HS Series Hot Water Hydraulic Separator/Buffer Tank
American Wheatley HS Series Hot water buffer tanks are designed to operate with modern high efficient low-mass modular boiler systems. The American Wheatley hot water buffer tank ensures minimal ΔT and provides the necessary thermal storage to prevent short-cycling that could occur during low load conditions.
In-line Air Separators Details
Wheatley’s In-line Air Separators series offer a lower-cost alternative for air separation in hydronic heating and cooling systems. The IAS / IASS series become a point of lower system velocity by changing the direction of flow through the device. This lower velocity, along with the change in direction allows air molecules to separate from water, rise within the inline air separator, and be discharged through the vent opening at top of the vessel either to the atmosphere or to an expansion tank. We also offer a MG-Magnetic Option for air separators, to see more reference to the printed catalog sheet in the tab section below.View Product Information
Relief Valves Details
The American Wheatley Relief Valve series is designed to relieve pressure at a predetermined set in hot water heating systems. Intended for liquid systems, or emergency steam relief only. Constructed in accordance with ASME section IV, Latest Edition, rated for emergency steam discharge by National Board of Boiler and Pressure Vessel Inspectors. American Wheatley’s Relief Valve is Available in ¾” with male or female inlet, consult with our staff for availability.View Product Information
Sediment Removal Separator Details
American Wheatley also offers a centrifugal type sediment removal separator. While the design is similar to the American Wheatley TAS Series air separator, the SRS sediment removal separator also offers the advantage of solids removal.
The tangential design allows for sediment removal through the vortex action, which forces suspended sediment to the outside of the vessel and into the bottom sump where it can be easily removed. The tangential action also creates a vortex that forces entrained air into the center, which is then removed through the top opening, vented to the atmosphere or sent to the expansion tanks.View Product Information
Suction Diffusers/Flow Diverters Details
Suction Diffusers | The Wheatley suction diffuser is designed to reduce space and installation costs by replacing a long radius elbow, strainer, and extended entry pipe on the suction side of the pump.
Flow Diverter | American Wheatley’s HVAC Flow Diverter is a combination of a 3/16” Stainless Steel Strainer and a Ninety Degree Elbow in Class 125/150 Flanged Ductile Iron Body design to save space and money. The integral vanes maximize flow efficiencies into the pump and the strainer offer pump protectionView Product Information
Surge Vessels Details
American Wheatley WSV Surge Vessels are intended to control water hammer shock, as well as pump starts and stop surges in commercial, industrial, and municipal applications. Fabricated with a large inlet connection to minimize pressure drop. The Surge Vessels is constructed in accordance with ASME Section VIII, Division I with the Latest Edition.View Product Information
Tangential Air Separators Details
The American Wheatley Tangential Air Separator line is constructed of Carbon Steel in accordance with ASME Section VIII, Division I, Latest Edition. We offer the Tangential Air Separator with an optional removable strainer to help remove air and particulates from your system. Available in sizes ranging from 2” – 16” and larger.View Product Information
Tank Accessories Features Details
American Wheatley offers some accessories for your tank, whether you’re looking to upgrade your system or starting from scratch we have you covered with our Carbon Steel Constructed Expansion Tank Saddle with adjustable, threaded NPT legs. Maybe you need a Liquid Level Sight Glass Assembly created with a sturdy brass water gauge that has a service rating of 125 psi at 350F or a Tank Drain and Fill forged with a cast bronze body and copper vent tubes with a maximum temperature of 240 F. Consult with our staff for availability.View Product Information
Triple Duty Valves Features
TDV Valves | Combination pump discharge valve functioning as a shut-off, check, and calibrated flow balancer. Available in sizes 1-1/2” through 12” with cast iron body. Threaded or flanged ends.
The unique quarter-turn Triple Duty Valves design offers backflow protection throughout a wide range of system balancing settings. Upon closing, the plug rotates to block the downstream port of the valve allowing pressure to equalize around the clapper so that it closes with little resistance. The final closing is accomplished by the plug camming against the backside of the clapper. The most satisfactory closure is accomplished by turning the plug to the normal tight fit, then bumping the plug lightly.View Product Information
Water Reducing Valves Deatils
American Wheatley Water Reducing Valves automatically maintain system pressure, also the Reducing Valves are equipped with a “fast-fill” lever that can be used to override automatic closing during purging. The Dual Control Valve consists of a Reducing Valve with an in-line pressure relief valve connected at its outlet end. Water pressure Reducing Valves specializes in reducing city water pressure to desired system pressure, Automatically feeds water when the pressure in a system drops below the setting of the valve. For more information on Water Reducing Valves reference the catalog sheets tab below this. Consult with our staff for availability.View Product Information
WPS Series Plain Steel Expansion Tanks Details
American Wheatleys WPS Series Plain Steel Expansion Tanks is ASME constructed and stamped National Board registered, is leak-proof due to every tank individually hydro tested. Manufacturer’s Data Report for Pressure Vessels, from U-1 available upon request. We also provide a few additional options for our WPS Series Plain Steel Expansion Tanks that include a complete accessory package that includes liquid level sight glass, tank fittings, and drainer. An internal Galvanized coating and saddles for horizontal installation to name a few. Consult with our staff for availability.View Product Information
Y Strainers and Baskets Details
American Wheatley offers a huge assortment of Y Strainers and Baskets, a few include Basket Strainers, Cast Iron Flanged, Fabricated Basket, Y-Type, Cast Iron Flanged, Y Type CI & Bronze Threaded, Y Type Stainless Steel Threaded, Fabricated Y-Type Fabricated T-Type. Our strainer materials consist of Stainless Steel Perforated Steel, 304 Stainless Steel has good corrosion and abrasion resistance as well as weldability and formability. It’s often used in chemical and food-processing equipment. For more information on an individual item listed or drop charts reference the catalog sheets tab below this. Consult with our staff for availability.View Product Information